Blusoak 3.0 Drip Tape 1m

BluSoak 3.0 is a low-flow, emitter-style drip tape designed to pair perfectly with Blumat sensors. With 15cm emitter spacing, it delivers deep, even hydration and excellent wicking throughout the soil. 

Operating best between 10–15 PSI, BluSoak 3.0 is the ideal choice for pressurised Blumat setups using a 1-bar pressure reducer. It’s not intended for gravity systems, but in any pump-driven or mains water installation, it provides unmatched consistency and control.

BluSoak 3.0 is a one-to-one retrofit replacement for the original white BluSoak 2.0 Driup Tape and has quickly become the favourite for its clog-resistant design, superior uniformity, and excellent value.

✔ 15cm emitter spacing for even, controlled watering
✔ Low-flow output matched to Blumat’s flow rates 
✔ Performs best at 10–15 PSI — perfect for pressurised systems
✔ Proven clog-resistant design tested in commercial grows
✔ Improved performance, reduced cost

Important Installation Notes: 

BluSoak 3.0 must be cut through the emitters, not between emitters.
Cutting between emitters can disrupt the engineered spacing and may result in uneven or non-functional water distribution. Always cut directly through an emitter to maintain proper performance.

Make sure all fittings are tightened fully to prevent leaks.
For best results, use a pair of pliers or channel-lock pliers to hold the black body of the fitting steady, then use your hand to tighten the collar until snug. This method typically gives you an extra ¼ turn versus hand-tightening alone.

Even small leaks reduce system pressure and flow where it matters most, which can lead to inconsistent watering and poor Blumat performance.